When removing the layout tape from the assembly, how should it be pulled?

When removing layout tape from an assembly, the appropriate method is to pull it at an angle. This technique helps to minimize the risk of damaging the surface of the assembly itself. Pulling at an angle effectively reduces the adhesion's effect, allowing the tape to release cleanly without pulling up any material or finish from the surface to which it was applied.

Using a straight out method could cause the tape to stick and tear, which may lead to unwanted residue or damage. Pulling quickly and forcefully can also create a similar risk, as it may not provide enough control over the lifting process, increasing the chance of surface damage or leaving behind tape remnants. A circular motion is not practical, as it can create unnecessary stress on the tape and the surface, potentially leading to inaccuracies or damage in both the tape and the assembly.

Therefore, pulling the tape at an angle is the best practice to ensure the integrity of the assembly remains intact.